Ok so a unit when it goes to fire at a unit, the target must be within it's max range. this is normally ok but for some things this is an issue. Say a unit that has to setup to fire, because that is what I am about to do. Certain units like say the xamel have to use a setup animation before firing.
So take the above picture. step A: unit sees target goes just into his range(red) and begins aiming animation.. step B: target moves out of range edge. Unit has to move to fire at target.
What happens is a unit moving, stopping, moving stopping over and over again.
so is there a way to have C, a minimum range(represented by green) to unit before it starts aiming to fire at target?
The reason I am asking is I have artillery units which I want to have a 3 second setup animation before they can fire. but the problem is they want to start the animation as soon as A is reached.. which is not close enough..
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum