Well that can be the texture on flats but on slopes i was thinking something like this :
and is it possible to make it so that they dont blend into each other like on some maps iv seen cause that look horrible.. I bet the problem with metging to textures on one map is the parts they meet in...what are the posible solutions?
On the gameplay of the map, for a 1v1 and for most maps in general, you want a nice, good, solid gameplay flow, with directions to push in and areas to contest, defensible points and flatlands etc.
You have a few defensible points, some interesting terrain, but only really one metal path, curving into the middle. If you push your com along here it becomes comwars in the centre (And if you dont, you lose those spots!) though i assume that hole is large enough to prevent you just camping all those middle mexes. The only other choice than to push com/cons into the middle is the 'special' spot (on the flats, which is only 1 mex to cap/defend, and the 'gimmick' spots on the hills. As general advice, id really avoid gimmick spots like that.
What can cap them? Air? In CA, Venoms? In CA arm would be mandatory on this map and it would be flea/venon wars for those hills and once they are capped, they wont change hands. I dont know, this might be interesting- but you've kind of weighed the metal a bit heavily in those spots.
The 'special' spots on the side hills give 28 metal in total, as much as -all- the regular spots on the ground together.
The kbot only spots give 12, which is a significant amount. The combined metal of all the regular spots + special spots vs the ones on the hills- the hills actually have more metal, by about 6-7.
Thats kinda excessive for 'gimmick spots'. I dont even know that the kbot spots need so much metal- just having kbot-only ridges is an advantage to kbots (Though this depends on if its BA or CA, CA kbots are more competitive on flat terrain, so rely less on ridges for viability).
Other than that looks kinda interesting, but id have to play it.
Damn. Iv been trying to add a new texture for the water cause it needs to be lava but after tweaking the smd file adding the new texture name i am not sure where and how i need to add the new lava texture so it replaces the default one.
Shit now i have another problem.It resizes the texture making it smaller which one bigger areas looks very repetetive. yeah..thing is that it resizes the texture.. the texture is big enough to not look repetitive but it resizes it.
Yeah saktoth is doing a great job in the texture department. Back to my question!!! why is my water texture gets resized!!!it is a 500x500 texture and the map is about 4kx4k. The middle pit should be at least half covered by it without repeating..Yet it resizes the texture and i get a few tens of repetitions on the pit,that of course looks butt ugly.
Users browsing this forum: No registered users and 4 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum